Cutting device
By dint of side hanging, the cutting device can fasten the replacement of knives. The cutting device is composed of a knife assembly, a power unit and a supporting bracket. Generally, hard blades are used for this cutting device, and they can be adjusted forward and backward or upward and downward.
Extruding device
The extruding machine device is composed of a bearing pedestal, a feeding section, the first barrel section, the assembly of extruding chamber, a screw rotor and a discharging device.
Installation of electric control part
Adapted electric control cabinet of the equipment should be put on the chute side of the bypass, better to be 0.8 m ~1.0 m away from the bypass, without any spacing object in between.
It is incorrect to install the control cabinet far away from the principal machine or even right in the face of the material outlet of the feed extruder, or on the side of the main motor, because the operators must pass by the material outlet of the extruder to carry out operation. This violates the common practice that "it is inadvisable to stand in the front of the material outlet of the extruder" and may cause potential safety hazard.
For the installation of on-site power supply, the connection can be carried out according to the drawing of electrical control, and the motor can be adjusted for its forward and backward rotation. There is an indication mark of rotation direction on the hood shield of each motor.
In addition, for the layout of wire casing for the principal machine, we should consider that there may be water on the ground around the extruding machinery, so the wire can be laid overhead or embedded under the ground instead of placing at the ground beside the extruder, otherwise long period of water invasion into the wire casing may cause disastrous aftereffect and the exposed wire casing on the ground is also not favorable for site cleaning.
No comments:
Post a Comment