Operation on TCXT Permanent Magenet Sleeve

TCXT series spout magnetic separator is a product researched and developed by Muyang. It is suitable for feed mills, cereal and oil processing plants, solvent factories and breweries in all scales, and generally installed in the processing lines.

Installation
***In order to prevent the machine from blockage caused by large sundries, this feed machine should be installed after a preliminary cleaner.
***This equipment should be installed in a vertical pipe and the height of vertical pipe section above the equipment should be≥500 mm.
***Because the impact action from the raw materials affects the iron absorption efficiency in certain degree, a buffer device should be set up at its upper part and the material flow rate should not be more than 1m/s.

Operation and precautions
***Do not knock the permanent magnet while installing for it is relatively fragile.
***Because this machine has a strong magnet field, it is forbidden to place any objects easily magnetized such as electric meters, watches and so on around it.

Repair and maintenance
***In order to assure the magnetic separating effect and avoid material blockage caused by too many metallic impurities adsorbed on the permanent magnet surface, it is necessary to regularly open the door to remove adsorbed impurities and other contaminants from the permanent magnet in each shift.
***The feed machinery does not need magnetizing within about 6-7 years under usual conditions, if its magnetic property is obviously lowered during operation, it should be magnetized again or the magnet blocks are to be replaced in time.
***Because of direct impaction and attrition of materials, the overhead guard and polar plate of the permanent magnet should be replaced in time if they are seriously abraded in service.