(1) All the mechanical equipments manufactured by Muyang are equipped with safety devices, which are consistent with modern technical level and universally effective safety rules prior to ex works, so that the customers can use the machines in accordance with the regulations.
(2) The enterprises are obligated to execute following regulations to guarantee operators' safety.
(3) The shield cap of belt and chain must be mounted at any moment and keep closing. It is very dangerous when they are opened or disassembled. It may cause casualty accident. This is also applicable for the preventive device of the manipulator.
(4) The safety limit switches should always be kept in good order. Overlap or discard of the safety limit switches is not allowed.
(5) The cover plate grating, grid bar or guard grating are usually installed and delivered together with the machine. They can only be disassembled with tools. And the machines with such kind of devices can never put into work until the above-said devices have been properly installed.
(6) The driving motor must be switched off completely to make the machine stop when carrying out inspection, commissioning, repair and maintenance. This can be done through a full-phase separating and lockable switch which is installed near the machine or on the operation desk, control panel on the site. It is not enough only to screw off the fuse wire!
(7) If the feed machine needs other energy like pneumatic, hydraulic, steam and hot water energy, it is necessary to cut off their energy supply or turn off the switch, and eliminate the pressure in the internal pipeline system of the machine.
(8) As for handling heated or cooled parts and components of the machine, especial care should still be taken for the danger of burning, to prevent any scald.
(9) If you have pressed the emergency stop switch to stop the machine and you want to reset the switch, so it is not permissible to only re-press this button to restart the machine. And the machine can only be started by re-closing the main switch first.
(10) If some feed machines are equipped with a local shutdown system, especial care should be taken. Read the instruction manuals attached with the machine carefully. In such machines with a local shutdown system, temperature will rise because pressure or vacuum will occur after they have been used for a period.
(11) If the operators employed cannot read or write, the owner has the duty to explain to them clearly where dangers exist and warn them that special attention should be paid.
(12) The cleaning, lubricating and oiling of the machine or its parts and components may be carried out only when the machine is stopped. If you have to climb on or enter the machine to do such work, the mandatory provisions shall be made without exception: the power supply of motors must be cut off completely and the switch must be locked, fix the rotor of the mixer before entering the mixer. Attention must be paid to safety measures for climbing.
(13) Be careful, sampling from inside the machine can never be carried out unless there is not any danger. Usually, the samples can be taken from the pipe under the machine instead of inside machine.
(14) Clear off the deposited dust, dirties and materials frequently. Keeping the machine clean can enhance production safety and the cleaning level of workshop, and is also beneficial to prevent dust explosion.
(15) If oil (grease) leakage occurs, clean it immediately and seal well the place where leakage occurs, for oil or grease leaked on the floor will easily bring about hazards to the operators.
(16) In production operation, the animal feed machines must be equipped with safety devices, which may be neither removed and abandoned nor reduced in functions. Otherwise, we are not responsible for any accidents resulted here from, and reserve the right to ascertain where the responsibility lies.
(17) Please execute the special regulations on accidents prevention in the operation manual provided by us.
(18) Only well trained workers can operate our machine.
No comments:
Post a Comment